Allied Data Technologies 811 Instalační manuál stáhnout pdf (Strana 80)

Chapter 6: WAN Configuration Examples

Page 78

6.3 Configuring a PPPoA connection with NAT

In this section is described how to configure a PPPoA connection (RFC2364 routed).

Follow the steps below to configure the CopperJet for PPPoA.

1- Go to Configuration -> WAN connections.

2- Delete any existing WAN connection by clicking on the Delete… link.

3- Click on Create new Service.

4- Select as WAN Service RFC2364 Routed Service attached to the Router.

5- Fill in the correct VPI and VCI values and Username and Password that is provided

by your ISP.

6- Click on OK.

7- Preferred is to have the DHCP Server of the CopperJet enabled.

8- Save the configuration (Configuration -> Save config and click on Save).

9- Make sure that your network card is configured correctly.

For more advanced settings, go to section

5.6.5 Configuring PPPoA routed service attached

to the Router.

6.4 Configuring a PPPoE connection with NAT

In this section is described how to configure a PPPoE connection (RFC2516 routed).

Follow the steps below to configure the CopperJet for PPPoE.

1- Go to Configuration -> WAN connections.

2- Delete any existing WAN connection by clicking on the Delete… link.

3- Click on Create new Service.

4- Select as WAN Service RFC2516 Routed Service attached to the Router.

5- Fill in the correct VPI and VCI values and Username and Password that is provided

by your ISP.

6- Click on OK.

7- Preferred is to have the DHCP Server of the CopperJet enabled.

8- Save the configuration (Configuration -> Save config and click on Save).

9- Make sure that your network card is configured correctly.

For more advanced settings, go to section

5.6.6 Configuring PPPoE routed service attached

to the Router

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 86

Žádné komentáře

Allied Data Technologies 811 Instalační manuál Strana 80